The Reasons Behind Why Your Toilet Won’t Flush – Tips & Guide by The Best Plumbers in Burnaby

The Intro:

Is there anything that may be more unpleasant — or more nasty — than using a toilet, only to find that it won’t flush correctly after you’ve done your business? The fact of the matter is that there are a great deal of potential causes for a toilet that does not flush properly. The first thing you need to do in order to fix the problem and get your toilet back up and running is to figure out why it won’t flush.

The following are some of the possible causes behind why the toilet isn’t flushing:

It appears that there is some kind of blockage in the piping system:

If the water in the toilet bowl won’t flow down at all, the problem is probably caused by some form of impediment, such as an excessive amount of paper being used or a small bathroom object that was flushed down the toilet by accident. You might give it a go to be plunged, but if that doesn’t work, you might have to hire a professional drain cleaning specialist.

There can be a problem with the ventilation in the drain line for the toilet.

In the event that air is unable to enter the drain in order to facilitate an effective flush, it is highly recommended that you seek the assistance of a qualified plumbing specialist.
It’s possible that the house’s primary drain is clogged up. Again, this is a situation that requires you to get in touch with a licensed plumber for assistance.

It’s possible that the siphon jet is clogged.

There is a little hole at the bottom of the bowl on many different types of toilets, particularly older versions. This hole is located close to where the water drains out. This component is known as the siphon jet, and when water from the flush is sent through it, it draws the water level in the bowl lower. To put it another way, the siphon jet is necessary for the toilet to flush effectively. This little aperture, however, has the potential to become obstructed with buildup and debris over time. It’s possible that the buildup can be removed; put on some rubber gloves and scrub it, or use a wire hanger to poke holes in it and pull out the goo.

There could be an issue with the tank that the toilet sits on.

Remove the cover and examine the device to ensure that everything is in working order; if the water does not flow from the tank into the bowl, there may be a problem with the mechanism that controls the flow of water.

It’s possible that the toilet is old.

Don’t ignore the one that’s staring you in the face the whole time: It’s possible that your toilet is simply damaged due of its age or because it was never all that high-quality to begin with. To put it simply, toilets do not last forever, especially if you purchase one that is on the more affordable side. If your toilet has just reached the end of its useful life, then it is time to get in touch with a licensed plumber to have a new one put in your home.

Do not be hesitant to get in touch with our plumbing specialists in Vancouver right away if you need any further assistance or troubleshooting.